Battery tester for all Lead-acid and LiFePO4 / LFP Lithium batteries
R579.00
TS-126 State of charge battery tester
Battery tester for all Lead-acid and LiFePO4 / LFP Lithium batteries
State of charge result in VOLTS and %.
Tests all 12V lead-acid and LiFePO4 / LFP Lithium batteries.
Easy to use! Connect clips to the battery and read the result.
The OptiMate battery tester’s microprocessor circuit draws very low power from the battery itself to determine and display battery status.
Easy to follow instructions are adhered to the rear panel of the tester.
12V: 1) Smart desulphation: 0.5V – 14.4V 2) BMW CAN-bus compatible: 5V – 14.4V
12.8V: 3) Low Volt Recovery: 0.5V – 14.4V 4) BMW CAN-bus compatible: 8.8V – 14.4V
STEPS: 9
FEATURES: OptiMate 4 Quad Program tests before & after charging and can recover a ‘dead-flat’ lead-acid & lithium (LiFePO4) battery from as low as 0.5 Volts.
INPUT: Global (100-240V 50-60Hz), high efficiency (CEC listed).
STYLE: Weatherproof case with wall mounts, with 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector.
SAVE : Low Volt Start of 0.5V + 2-step* desulphation recovery (*1-step low volt pulse save during CAN-bus mode).
SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected.
INCLUDED: weatherproof battery lead, battery clip set & hanging hook.
WARRANTY: 3-year limited replacement warranty.
What does the Quad program mean on the OptiMate 4?
OptiMate 4 Quad Program includes four charging programs; the standard program for lead-acid batteries is supposed to be used when connecting directly to the battery, the CANbus (BMW) program for lead-acid batteries allows charging and maintaining via the DIN socket on BMW Motorcycles (models 2004 and later).
The standard program for lithium batteries is supposed to be used when connecting directly to the battery, the CANbus (BMW) program for lithium batteries allows charging and maintaining via the DIN socket on BMW Motorcycles (models 2004 and later).
Does OptiMate 4 have a battery recovery program?
Yes, the standard program has the most advanced recovery program which saves ‘dead flat’ sulphated batteries from as low as 0,5V.
Which program do I need to select to charge over the 12V socket on my BMW? You’ll need to select Program 2 (Pb-CAN-bus) or Program 4 (LFP-CAN-bus) depending on the type of battery in your BMW motorcycle. Program 2 is for a 12V sealed lead-acid battery – your sealed battery may be marked 12V VRLA, GEL or AGM. Program 4 is for a 12.8V LFP (Li-Ion with chemistry LiFePO4) battery.
How do I select the correct program? Disconnect the OptiMate 4 from the battery or vehicle. Push and release the pushbutton switch. The mode selection changes when the button is released. Continue to press and release until the desired program has been selected. If no futher selection is made for at least 3 seconds SAVE (#3), CHARGE (#4), OPTIMIZE(#5) and TEST (#6,7, 8) LEDs flash twice to confirm selection is in memory.
What’s the difference between the OptiMate 4 Quad Program and the OptiMate 4 Quad Program Premium edition? The standard edition is delivered with a set of battery clips (O-04), a permanent battery lead (O-01) and a handlebar hanging hook to suspend the charger from the handlebar. The Premium edition includes all the same accessories PLUS a SAE to DIN adapter (O-19) to connect directly to 12V DIN sockets on BMW and Triumph motorcycles.
I want to use my OptiMate QUAD over the 12v socket. Which additional connector do I need?
You will need one of the OptiMate BIKE plug cables (O-02, O-09, O19 or O-29)
Can I charge my Triumph motorcycle through the 12V DIN socket?
Yes, IF the socket is ‘live’ (hot) when the motorcycle ignition is turned off. (TIP: Recent model Triumph Tiger 850/900 and 1200/1250 have a live socket near the instrument panel.). Select program 1 or 3 for direct-to-battery charging as the socket is directly connected to the battery.
What type and size batteries does OptiMate 4 Quad Program charge?
STD, AGM and GEL 12V lead-acid & 12.8V / 13.2V lithium LFP (LiFePO4) batteries used for engine start & deep cycle applications. For lead-acid batteries from 4Ah to 60Ah for 24-7 battery maintenance and for lithium batteries from 2Ah to 15Ah for 24-7 battery maintenance.
How fast does OptiMate 4 recharge batteries?
Charge time on a flat but otherwise undamaged battery: a 12Ah battery should take no more than about 12 hours to progress to the self-discharge check. Deep-discharged batteries may take significantly longer, a full charge may not be achieved within the hour charge safety limit. In this case.
How to charge and maintain your BMW motorcycle battery?
TS-120 Battery and charging system tester The 3 Step TEST! Checks battery charge level. Records lowest start volts. Verifies charging voltage. Checks if alternator is…
TESTMATE AUTO (200Ah) Professional affordable 12V battery tester Select battery type and Ah / CCA, then TEST For all battery technologies (STD, AGM, GEL) Result…
R3,038.00Original price was: R3,038.00.R2,899.00Current price is: R2,899.00.
OptiMate 6 Ampmatic and TS-120 Battery and charging system tester bundle OptiMate 6 Ampmatic, with 5Amps of charge current, is an advanced battery saving charger,…